Countersink and Deburring Tools

SVASATORI 3 TAGLI HSS 5% Co

3 Flutes Countersinks in HSS 5%CO. 63 HRC or carbide K.15. 90 °, 60 °, 100 °, 120 ° cylindrical shank and morse taper. From Diam. 4.3 to Diam. 100. They are suitable to perform rabbets on all materials. They can also be used for bevels, having the care to reduce the values ​​of both […]

SVASATORI 1 TAGLIO HSS 5% Co

Single Flute Chamfering cutters HSS 5% Cobalt 63 HRC. 90° and 60° cylindrical shank and Morse Taper. From Diam. 4 to Diam. 50. Greater countersinking capacity from the point to the outside diameter. Simultaneous drilling and countersinking on thin elements. They are suitable to perform both bevels that rabbets on all materials which require a […]

SBAVATORI CON FORO HSS 5% Co

Deburring Tool with hole HSS 5%CO. 63 HRC. 90 ° and 60 ° cylindrical shank and Morse Taper. From Diam. 10 to Diam. 50 The deburring tool “with hole” is more particulary designed for countersink, for the execution of little chamfer,and for use with light metals and plastics. The surface obtained is smooth and without […]

SVASATORE PER TUBI INTERNO ESTERNO HSS-E, SVASATORI PER TUBI

Pipes Deburrers Inter/Exter 3 Flutes in HSS-E. 90° Cylindrical Shank. TYPE 01: Exter:   5,2-13,5 | Inter: 2,0-11,0 TYPE 02: Exter: 12,2-30,0 | Inter: 10,0-31,0 TYPE 03: Exter: 18,0-48,0 | Inter: 20,0-50,0

ALLARGAFORI PER LAMIERA HSS

This tool have been built to drill flat materials of thickness till 2 m/m and pipes till thickness 3 m/m. With each tool a large range of holes can be produced on every kind of material without pre drilling. TYPE 0: From Diam. 3 to Diam. 14 TYPE 1: From Diam. 6 to Diam. 20 […]

UTENSILPUNTA HSS

The Polledri countersink for drill permits you to drill and countersink simultaneous. The drill countersink adapts to most standard twist drills within the range from Ø 3 to Ø 30. Fixed on the drill by two screw on its back

UTENSILMASCHIO in HSS

This tool permit threading and bevelling in one operation. The countersink for tap is formed from 3 parts: one ring, one spring and one head. The ring is fixed with 2 screws at 90° degree on the shank of the tap in the correct position, so that when the tool work the spring is not […]